3 Ways To Prevent Electric Korslerting

The rise of fires that occur due to electrical short circuit becomes a reflection for us to use electricity wisely. Electricity is an important requirement in daily life, but excessive use without supervision can pose a threat. One of them is the threat of house fire. Shorted electrical or short circuit electric current is a relationship with a very small electrical resistance, resulting in a very large electric current. If not taken seriously it can cause an explosion and fire. Many factors cause an electrical short circuit. The most frequent cause is the result of human negligence. Starting from the use of cables or installations that are not according to standards to the issue of awareness to carry out maintenance and maintenance of electrical installations. Hand over electrical repairs at home to residential electrician Columbia SC.

House fires are certainly a threat so scary. Now, to avoid this, it’s good we can know more clearly about how to prevent an electrical short circuit. Consider the following ways.

Avoid installing electrical installations that are too many connections
As much as possible avoid too much cable connection. When the connection is not properly installed it can cause sparks. Always recheck the cable connections that are already installed to make sure the cables are installed properly.

Re-check the MCB Electric device
MCB (miniature circuit breaker) is a device that functions for electrical circuit breakers if it experiences a sudden or slow rise until it reaches the maximum capacity. To better secure the electricity network, MCB can prevent overload / shorting from spreading throughout the electricity network in other parts of your home. So, if there is short/overloaded electricity in a certain area, the MCB (mini switch) will go down automatically.

Pay attention to the electrical installation cable
The cable is an important component in the electrical installation that functions as a conduit of electric current from the PLN electricity source to the source of home electrical equipment. Perform routine checks on the condition of the cable wrap insulation, if any insulation is peeled off or has thinned to be replaced immediately. Use the type and size of the cable following the intended current capacity.

Leave a Reply

Your email address will not be published. Required fields are marked *